For a product information brochure, call, write or fax to:
Taylor Design Group, Inc.
P.O. Box 810262, Dallas, TX 75381
Tel: (972) 418-4811 Fax: (972) 243-4277
Web Site: www.incra.com
PRODUCT INFORMATION
8
Made in America by:
Taylor Design Group, Inc.
■
P.O. Box 810262
■
Dallas, Texas 75381 1195
Printed in the U.S.A. © 1995, Taylor Design Group, Inc. INCRA is a registered trademark of Taylor Design Group, Inc.
WARRANTY
Taylor Design Group, Inc. warrants this product for one year from date of purchase. We will repair
any defects due to faulty material or workmanship, or at our option, replace the product free of
charge. Please return the failing component only, postage prepaid, along with a description of the
problem to the address below. This warranty does not apply to parts which have been subjected to
improper use, alteration, or abuse.
LIFETIME WARRANTY ON POSITIONING RACKS
If an INCRA positioning rack in this tool becomes damaged for ANY reason, Taylor Design Group
will replace it free of charge for as long as you own your tool. Return the damaged rack, postage
prepaid, and allow 1 to 2 weeks for delivery.
NOTE:
Replacements cannot be sent unless damaged racks have been received by Taylor Design Group.
FIG. 16
Shaping
FIG. 17
Shaping setup
Distance between stock and
outfeed fence – micro adjust
outfeed fence forward by this
amount
Outfeed fence
Infeed fence
Many shaping operations involve the removal of
the entire edge of a square piece of stock as it is
moved past the cutter. Once the stock is
removed from the edge, it becomes necessary to
support the freshly cut surface by moving the
outfeed fence forward. Although similar to
jointing, the setup is slightly different. Here’s how:
Install router bit and set desired depth of
cut.
Adjust fence gap as necessary (see Gap
Adjustment on page 5).
Adjust infeed/outfeed fences to the
in-line/mid-range position as described on
page 5.
Adjust the location of the Intelli-Fence at
your router table to achieve the desired cut
profile. Use a scrap piece of wood and make trial
cuts to help in determining the fence position.
Make a fresh test cut about 3" long on a
piece of scrap stock, then turn off the
router. You’ll notice a gap between the freshly
cut surface and the outfeed fence, Fig. 17.
Simply micro adjust the outfeed fence forward by
this amount to support the stock’s edge as it
passes the cutter.
2
5
3
4
1
Shaping
For a product information update on the complete
INCRA line of tools, please see your nearest dealer.
If you are unable to locate a store nearby, or if you
have trouble finding a particular product, we will
honor your order directly.
(2 pages)
(6 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals