Incra TS-LS Metric Extended User Manual download pdf

INCRA TS-LS

Metric Extended Capacity Instructions

Installing your new fence system with the TS-LS Owner’s Manual will provide 810mm of right-side

ripping capacity. These instructions will increase that capacity to 1320mm on most saws.

Note: When installing the longer 92” rails, the only departure from TS-LS Owner’s Manual is that

the right-hand end of the rails should be 1650mm from the blade instead of 45” (page 5, step 5).

Complete the entire installation and set the LS positioner’s steel primary scale before using these

instructions to set up the system for extra capacity.

1. Slide the “floating EL” stops from Hardware Pack B-05 into the T-slots on the bottom of the

main rails and tighten them against the edges of the base clamps that are nearest the blade

(see page 12 of the TS-LS Owner’s Manual). These stops will be used to position the base

on the rails for cuts made from 0 – 810mm wide.

2. If you haven’t already done so, install the rail support legs 200 – 400mm from the ends of the

rails. Set the levelers so the ends of the rails don’t appear to rise or sag when sighting down

the rail’s length.

3. Set the fence 510mm from the blade using the steel scale and fully lock the red lever on the

LS positioner. Leave the ends of the fence unlocked.

4. Clamp blocks of scrap wood onto the infeed and outfeed main rails so they rest gently against

the face of the fence. (Fig. 1)

Fig. 1- Scrap wood blocks clamped to rails

5. On the dual-pilot rectangular nuts that hold the base clamping knobs, loosen the small set

screws with an Allen wrench so the knobs and base assembly can slide freely up and down

the rails. A drop of Loc-tite on the threads of the set screws will hold them in place in the nuts

if you choose to leave them loose.

1 2

INCRA TS-LS Metric Extended Capacity Instructions Installing your new fence system with the TS-LS Owner’s Manual will provide 810mm of right-side rip

Page 2

6. Unlock the LS positioner and slide the base assembly toward the end of the rails. Fully lock the red lever when the 0mm mark on the steel scale

No comments

Incra TS-LS Metric Extended User Manual