Incra Build-It Starter Kit User Manual download pdf (Page 3)

anding end grain can be a chore. It’s difﬁcult enough just because it’s the hardest part of the board to remove saw marks from. Add

to that the small surface area and you run into problems keeping the surface square and ﬂat as you sand. This little sanding jig makes

handling pieces small and large a snap, taking advantage of the power sanding capabilities of a disc sander while providing support for

the workpiece. It can be used as a slider, allowing you to maintain even wear across the face of the sanding disc. If your pieces are

really small, you can lock the Miter Slider in place and just slide your work piece down the fence to the sanding disc.

Add a Miter Slider and (2) T-Slot Panel

Connectors to a small Build-It Panel and

place in the miter slot at your disc sander.

Adjust the Miter Slider to ﬁt your slot. Cut

a piece from another Build-It Panel to ﬁll

the gap between the existing assembly

and your sanding disc. Cut the slots in

the fence as shown then attach with

(2) 1/4-20 x 1-1/2” hex bolts with washers

and Build-It Knobs. The slotted holes

permit adjustment to almost any angle.

Caution: If you have a small side table

on your disc

sander, you

should only

use th is jig

with the Miter

Slider “locked”

in the slot to

create a sta-

tionary jig.

Disc Sander Jig

Fig.1 Fig.2

Fig.3

Detail 3A

Build-It Platform Components Required:

• 2 Small Build-It Panels or 1 Small & 1 Large

• 1 Miter Slider • 2 T-Slot Panel Connectors

• Build-It Knobs

Just add:

System

/16” wide x 4

/2” long slots

/4”-20 x 1

/2” hex bolts

angle to suit

Trim for about 1/32”

of clearance between

edge of panel and

sanding disc

3”

16”

/2”

/16” through slot

/2”

/4”

Plan # 004

Available online at w w w.i n c ra . co m

1 2 3 4 5 6

Comments to this Manuals

No comments

Incra Build-It Starter Kit User Manual Page 3

Comments to this Manuals

Related products and manuals for Tools Incra Build-It Starter Kit