Incra Router Table Stands Addendum User Manual download pdf

w w w. i n c r a . c o m

Manufactured by:

Taylor Design Group, Inc.

P.O. BOX 810262 Dallas, TX 75381

www.incra.com

INCRA Tools are protected by one or more of the following US patents:

#4,793,604, #4,930,221, #5,195,730, #5,275,074, #5,423,360, #5,716,045, #6,237,457,

#6,557,601, #6,672,190. Other patents granted or pending. rev.11.03.10

INCRA is a Registered Trademark of Taylor Design Group

Side Winder Side Crank Installation on INCRA

Router Table Stands

Note: This addendum replaces Fig/Step 10 & Fig/Step 11 of the Woodpecker provided mounting instructions.

Please follow all assembly instructions of the original manual up to Fig/Step 10 before using this addendum.

MADE IN THE

USA

If your INCRA router table stand is already assembled you will ﬁrst need to remove the table top and remove the

front top stretcher. Remove the lower 1/4-20 x 1/2” hex bolt from the left end of the stretcher, Fig. 1. Loosely

attach the Side Winder Crank’s side panel to the stretcher using the provided 1/4-20 x 7/8” hex bolt, washer

and square nut. Place another 1/4-20 x 7/8” hex bolt with washer

through the lower hole on the Crank’s side panel and add the large

gold washer to the fastener before loosely threading on the square

nut, Fig. 2.

Re-assemble the stretcher to the stand sliding all 3 of the square

nuts on the left end of the stretcher into the t-slot in the leg.

Make sure the Crank’s

side panel is parallel

to the leg before

tightening all of the

mounting bolts,

Fig. 3.

Using the remaining

hole in the side

panel as a guide,

drill a 9/32” hole

through the front

stretcher, Fig. 4.

Place a ﬂat washer

on the remaining 1/4-20 x 7/8” hex bolt and insert through the

hole on the side panel. Add a split lockwasher and a square nut

then tighten the assembly in place, Fig. 5.

Continue with Fig/Step 12 in the Side Winder Owner’s Manual.

Fig.1

Fig.2

Remove front

stretcher and remove

lower hex bolt from

left end

Fig.4 Fig.5

1/4-20x7/8

hex bolt with

washers

Square

nuts

Large washer

this bolt only

Square nuts

captured in

T-Slot on Leg

Re-assemble Stretcher to Stand

Fig.3

Drill 9/32”

hole through

stretcher

1/4-20x7/8

hex bolt with

washer.

Secure with

lockwasher

and

square nut

Router Table Stands 1

Summary of Contents

Page 1 - Router Table Stands

w w w. i n c r a . c o m®Manufactured by:Taylor Design Group, Inc. P.O. BOX 810262 Dallas, TX 75381www.incra.comINCRA Tools are protected by one or m

Comments to this Manuals

No comments

Incra Router Table Stands Addendum User Manual

Browse online or download User Manual for Hardware Incra Router Table Stands Addendum. INCRA Router Table Stands Addendum User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Incra Router Table Stands Addendum